| PNEUMATIC
|
| *Output Pressure |
0.2-1bar (3-15psig) ; |
| *Air Supply |
Oil free, dry air, filtered to <5 microns;
1.4-10 bar (20-150 psig) |
| *Flow Capacity |
<1.5nl/min |
| *Air Consumption |
<1.5 nl/min typical |
| *Response Time |
</=650msecs from 10 to 90% or
</=350ms from 90 to 10% of output pressure into a 4.5cc load) |
| *Linearity |
+/-0.5% of span |
| *Hysteresis |
+/-0.3% of span |
| *Temperature Effect |
Typically less than 0.2% span/degC between -40°C to +85°C |
| *Supply Sensitivity |
Less than+/- 0.15% of span for supply pressure change |
| *Connections |
customised to suit customer requirements |
| PHYSICAL
|
| *Operating Temperature |
-40°C to +85°C |
| *Weatherproofing |
IP20 |
| *Vibration |
Output pressure changes less than 2% for 2g sine 20-100Hz, |
| *Electromagnetic Compatibility |
Compliant with EC requirements EN
50081-2:1994(Emissions) and EN50082-2:1995(Immunity) |
| *Material of Construction |
Zinc diecasting with nitrile diaphragms, customer specific enclosures available |
| *Mounting Position |
Any, to be specified by customer |
| ELECTRICAL
|
| *Electrical Signal |
4-20mA (two wire); |
| *Loop Resistance |
230Ohm |
| *Failure Mode |
Signal falls to below 15mbar (0.2psig) in <
2sec, when input signal fails |
| *Insulation Resistance |
>100MOhm at 850Vdc, electrical terminals to case |
| *Connections |
Clamping screw connector terminals or flying leads to customer requirements. |
| ORDERING INFORMATION |
Options to special order:
Standard 1/8” ported base
Alternative pressure ranges
Optional Enclosures
Orientation and Application Specific Calibration set-up |
|
TYPE 120 Brochure
TYPE 120 Manual
|
Low Cost OEM I/P
