| PNEUMATIC |
| *Output Signal |
*0.2-1bar (3-15psig); minimum outlet pressure less than 15mbar (0.2psig) |
| *Air Supply |
Oil free, dry air, filtered to 5 microns; 1.5-3.5bar (20-50psig) or at least 0.7bar above maximum output pressure |
| *Flow Capacity |
Up to 150Nl/min (5scfm) |
| *Air Consumption |
0.2 l/min typical low pressure (0.007scfm) |
| *Response Time |
5 seconds (10 to 90% or 90 to 10% of output pressure into a 5 litre load |
| *Total Error |
+/-0.25% of span (typical, independent error includes the combined effect of non-linearity, hysteresis, deadzone and repeatability |
| *Temperature Effect |
Typically less than 1% span for span and zero between 0°C and 50°C |
| *Supply Sensistivity |
Maximum of +/-2% of outlet pressure at extremes of supply range |
| *Connections |
1/8" NPT female |
| PHYSICAL |
| *Operating Temperature |
-10°C to +60°C |
| *IP Rating |
IP40 |
| *Vibration |
The unit possesses a high degree of immunity |
| *Electromagnetic Compatibility |
Compliant and CE marked in accordance with the EC E.M.C. directive. Tested to standards: BS EN50082-2: 1995, BS EN50081-2: 1994 |
| *Material of Construction |
Anodised natural aluminium |
| *Mass |
600g |
| *Mounting Position |
The instrument can be mounted in any orientation. A rail clip is provided with each instrument for TS32 (EN50035)/TS35 (EN50022) rail |
|
ELECTRICAL |
| *Electrical Signal |
4-20mA (two wire); load presents 10 volts (+/-0.5V) constant voltage drop to the current source |
| *Failure Mode |
Signal falls to below 15mbar (0.2psig) when input signal fails |
| *Connections |
Two part quick release terminal block with capacity up to 2.5mm2 cable |
| MANIFOLD |
| *Materials |
Aluminium extrusion, clear anodised, nitrile 'O' ring seals |
| *Port Sizes |
Supply and output 1/4" NPT |
| *Proof Pressure |
10bar (150psig); pressure should be regulated to converter requirements. WARNING: maximum pressure should not be exceeded for safety reasons. |
| Note: It is recommended that an appropriate filter-regulator be fitted to supply all converters |
Advanced electronic control
