Home › Environmental › Parameter Measurement › LSI LASTEM Wind Vanes
LSI LASTEM Wind Vanes
Standard wind vane (direct output)
 DNA310#C
DNA311#C
DNA314#C
When you require a low threshold and good accuracy, even at wind speeds that are low, the LSI LASTEM the Standard wind vane with direct output is the answer.
DNA310-311#C uses a Hall-effect encoding system.
Power consumption during very low energy applications can be reduced with the DNA314#C as it features a potentiometer. For very cold environments, DNA311#C features heaters which help it avoid ice formation.
Standard wind vane (analog output)
DNA810
DNA811
DNA814
DNA815
DNA816
All of these models use a Hall-effect
encoding system.
For very cold environments, DNA811-815 features heaters which help it avoid ice formation.
|
Downloads
Datasheet
|
Accessories
|
DYA046 Coupling bar For WS+WD sensors
on � 45 �65 mm pole
DZC404 Calibration certificate Included in
DNA010-011#C
DNA110 Cable for DNA31x#C L = 10 m
DNA125 Cable for DNA31x#C L = 25 m
DNA126 Cable for DNA31x#C L = 50 m
MG2252 7 pin free male connector for DNA31x#C
DWA510 Cable for DNA81x L = 10 m
DWA525 Cable for DNA81x L = 25 m
DWA526 Cable for DNA81x L = 50 m
DWA527 Cable for DNA81x L = 100 m
MG2251 7 pin free female connector for DNA81x
sensors
DNA217 Spare part: rotor
MC1040 Spare part: screw for DNA217 rotor
MM2025 Spare part: bearings
|
Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.
Back To Last Page
|
|
|
|
