|  Suitable
for CATV systems using F connector coaxial cable.
For frequencies between
5MHz and 1GHz.
Suitable for power sources
of up to 140V AC peak.
For coaxial (or twisted pair) CCTV lines use
the ESP CCTV models. For coaxial RF lines use
the ESP RF models. Transients can also be conducted
into CATV systems via the mains power supplies. For mains power protectors
see the high current or low
current models.
Application
Use to protect CATV consumer installations.
Features and benefits
 Restricts let-through
voltage to below the damage levels of interface circuitry.
Provides repeated protection
in lightning intense environments.
Low attenuation and
high return loss over a wide range of frequencies ensure the protectors
do not impair system performance.
Carries AC or DC power.
Substantial earth termination.
Supplied ready for
flat mounting.
Strong metal housing.
ESP CATV/F installed in a basement or garage near
where the coaxial cable enters the building.
Installation
Connect in series with the coaxial cable either near where it enters
or leaves the building or close to the system's earth star point (to enable
a good connection to earth).
ESP CCTV Brochure
|
PROVISIONAL
- (Contact Keison Products for the latest information)
| Electrical Specification
- ESP CATV/F |
| Maximum working voltage |
140V (DC or AC peak at 5µA) |
| Current rating (signal) |
4A |
| Characteristic impedance |
75ohm |
| Bandwidth |
5MHz - 1GHz |
| Return loss over bandwidth |
=>20dB |
| Insertion loss over bandwidth |
<=0.4dB |
| Transient Specification
- ESP CATV/F |
Let-through voltage (note 1)
5kV, 10/700µs test to:
BS 6651:1999 Appendix C, Cat C-High
ITU (formerly CCITT) IX K17 |
250V |
| Maximum surge current (note 2) |
3kA |
1. The minimum transient voltage let-through the protector
throughout the test (+/-10%). Response time <10ns.
2. Tested with 8/20µs waveshape to ITU (formerly CCITT), BSI 6651:1999
Appendix C (>Cat C-Low).
| Mechanical Specification
- ESP CATV/F |
| Temperature range |
-25°C to +70°C |
| Connection type |
F female |
| Earth connection |
approx 9.5mm (3/8") diameter earth stud |
Weight:
unit
packaged |
0.14kg
0.15kg |
|
|
